How to configure PAT to pull an IP address from cable modem on a Cisco 800 series router?
I have a Cisco 800 series router, but I don’t think I can get a static IP address from my ISP. I need to configure port address translation but I’d hate to have redo it every time my cable modem gets a different IP.
Similar Posts:
- What type of modem and cable do I need to dial into the aux port of my cisco router?
- NAT Configuration on a Cisco Router
- What ip address do hackers use when you are using a router?
- How does the web determine the ip address from the doman name?
- How can i configure ports on a Cisco 2950 switch?
Extend This Post Reach
You need to setup your cable modem to route rather than bridge. That way you can have a set IP on the inside interface.That is if your modem supports that.
Then you could just overload the IP on the subnet of the inside interface of the modem.