Tips and Trick About Cisco » Ports http://www.ciscotrick.com All information tips and trick about Cisco Sat, 28 Nov 2009 13:51:03 +0000 en hourly 1 http://wordpress.org/?v=3.2 How do you configure voice and data vlans on a Cisco 2950 switch? http://www.ciscotrick.com/how-do-you-configure-voice-and-data-vlans-on-a-cisco-2950-switch/ http://www.ciscotrick.com/how-do-you-configure-voice-and-data-vlans-on-a-cisco-2950-switch/#comments Tue, 05 May 2009 17:27:58 +0000 mekichan http://www.ciscotrick.com/computer-networking/how-do-you-configure-voice-and-data-vlans-on-a-cisco-2950-switch/



I have a Cisco 2950 switch. I am running a data and voice VLAN. I have my last 2 ports set for trunking and I am pulling both vlan information from a 3650 Switch. Right now all my data traffic goes Thurugh but not my voice vlan. Am I doing something wrong?


Extend This Post Reach]]> http://www.ciscotrick.com/how-do-you-configure-voice-and-data-vlans-on-a-cisco-2950-switch/feed/ 1 How do I construct a Cisco IOS configuration to run a snake test? http://www.ciscotrick.com/how-do-i-construct-a-cisco-ios-configuration-to-run-a-snake-test/ http://www.ciscotrick.com/how-do-i-construct-a-cisco-ios-configuration-to-run-a-snake-test/#comments Mon, 20 Apr 2009 21:25:04 +0000 mekichan http://www.ciscotrick.com/computer-networking/how-do-i-construct-a-cisco-ios-configuration-to-run-a-snake-test/




I need to run a “snake test” on a Cisco switch. Assuming I have 8 interfaces, how would I construct a configuration in Cisco IOS to perform a snake test? [In case you don’t know, a snake test is where you connect ports 2 and 3, ports 4 and 5, ports 6 and 7, with Ethernet cables and inject traffic into port 1 so that the packets will traverse the snake. Packets enter port 1, go out port 2 and into port 3, go out port 4 and into port 5, etc.


Extend This Post Reach]]> http://www.ciscotrick.com/how-do-i-construct-a-cisco-ios-configuration-to-run-a-snake-test/feed/ 1